Bright Sights high visibility gun sight coatings increases the contrast between the front and rear sights, and the contrast between the sights and the target. This improved contrast provides for quick sight alignment, faster target aquisition and allows for faster and more accurate shot placement.
Bright Sights is a tough durable coating that stays on firearm sights, even under the extreme heat and vibration of rapid fire.
Bright Sights is used by Professional Gunsmiths, Gun Owners, Hunters, Competition Shooters, Tactical Units, and Law Enforcement Agencies throughout the United States and many foreign countries.
Bright Sights 'Ghost Glow' is a light activated substance that must be charged with light to glow in the dark. This can be sunlight, a light bulb or even the beam of a flashlight. The duration and intensity of the light will determine the time and intensity of luminescence. 'Ghost Glow' is not intended to be a replacement for true night sights, but as an enhancement to our high visibility gun sight coatings.
Ghost Glow coatings are not designed to be used alone, but as an enhancement to Bright Sights high visibility gun sight coatings. Best results are achieved by combining the two different coatings of the same color. A small amount of each coating should be mixed outside of each colored vial. The mixing ratio recommended is 75% Ghost Glow and 25% High Visibility Gun Sight Coating.
'Ghost Glow' is made from the same tough, durable coating as our Bright Sights High Visibility Gunsight Coatings, and just as easy to apply.
Bright Sights Color Options
|3cc Bright Sights ProKit® Colors||3cc 5 Color ProKit® with Cleaner|
|3cc Bright Sights Ghost Glow||
6 Color Ghost Glow Kit
Kit Contains:Bright Sights - Yellow, Orange, Green
Ghost Glow - Yellow, Orange, Green
Bright Sights Application Directions
Remove all oil from your sights using Bright Sights Cleaner and a cotton swab.
Shake container firmly to mix the coating.
If you have the Bright Sights Ghost Glow, mix 75% Ghost Glow with 25% regular Bright Sights of the same color.
If you have dot sights, use a Bright Sights Applicator or toothpick and dip just the tip into the coating. Carefully place this drop of coating on to your sight. Repeat to make the dot larger or higher
If you have a bead, blade or ramp sight, use a small artist's brush.
CLOSE THE CONTAINER. Do not let the coating dry out!
You may clean up using water and a damp rag.
Allow your sights to dry for 48 to 72 hours to cure properly.
Bright Sights Cleaner